Firewall 27-03
The Nose Gear brackets need to be riveted to the firewall angles and the tunnel sides. Some of the 470AD4-6 can be set with the squeezer and longeron yoke but the remainder are unreachable. I…
Articles by Chris
Firewall 27-02 to 27-03
All parts for section 27 deburred and primed apart from the stainless steel items. These took quite a bit of deburring particularly where the holes had been punched. I used a selection of needle files…
Firewall 27-01
Here we go again! All parts found for the firewall. The firewall gussets are in bag 3063 which I discovered after 30 mins of looking for them on the shelf. I should have consulted the…
Fuselage 26-21 to 26-22
This hasn’t been my favourite part of the build but it’s finished. Riveting the baggage ribs to the bulkhead presented an issue where I couldn’t get the gun on the baggage rib side due to…
Sollas fly-in beach landing
A fantastic day out in a friend’s RV6 to the Sollas fly-in on North Uist. There can’t be many places where you can do this and it was totally awesome. The sand was smooth, solid…
Fuselage 26-14 to 26-20
Fuselage bottom skin mounted vertically to assist with riveting the bottom skin. Just had to wait for assistant riveter to come off night shifts. There are a couple of rivets which are virtually obscured by…
Fuselage 26-11 to 26-14
Doublers and skin stiffeners back riveted to the Centre Bottom Skin. I had a few issues with back-riveting the 426-4 rivets and they aren’t as consistent as I would like but they are acceptable. I…
Fuselage 26-08 to 26-11
Tonight I added the F-01405 bulkhead to the Inboard Seat Ribs. Once this is done a bulkhead angle is match drilled and then riveted to the bulkhead. Although it shows where not to rivet this…
Fuselage 26-02 to 26-07
A goodly amount of construction now and the section is looking like a bit of an aeroplane. Lots of stiffeners, routing angles, nutplates and brackets for the seat belts to be riveted to the seat…
Section 26-02
Doublers added to outboard baggage ribs.