New spray booth
Some call it a gazebo, I call it less Smoke Grey dust in the workshop. Time now to get on with building again. Protective polystyrene, plastic sheets and ventilation fitted. All of Section 26 parts…
Read MorePriming
Aft fuselage – priming
Decided to prime as much as possible even if the part hasn’t been dimpled yet. I have dimpled after priming before and the EkoPrime seems to flex with the indent. The new ventilation system was…
Spraybay ventilation
Just about to start priming a lot of tail cone parts and having cleaned the workshop last week of all the priming dust, I am going to try a little extraction this time. I’m not…
Spray bay
After my first session spraying primer I realised that the spray had gone everywhere in the workshop leaving a fine coat of grey dust on everything. Solution: shower curtain spray bay suspended by steel wire…
Priming – first go
It had to happen and after much consternation I got going with priming the VS parts. I have absolutely zero spraying experience so this was a voyage into the unknown. I had purchased an Iwata AZ3…